AA Industrial-duty gas and diesel compressors are designed for applications that require air on the go. Built for durability and reliability with features designed to make these compressors more straightforward to maintain than any other compressor in this class. The engine is standard on the driver’s side of the vehicle. The unloader is at your fingertips, so you can unload the compressor before starting to increase solenoid and starter life. The receiver protects the transfer tube for safety.
With the capacity to run 1-inch impact wrenches and an assortment of air tools, this is the compressor you need to get the job done.
Features:
- 19 cfm @ 175 psi
- 5000 Watt Generator
- No Start-up Kit Required
- Optional 5-Year Pump Warranty
- Access to compressor valves without compressor head removal
- The alternator on the drive engine
- ASME tested powder coated steel tank
- Bearings on both ends of the crankshaft
- Centrifugal unloader
- Critical controls protected by compressor base plate
- Disk and spring valves
- Drive engine on the left side for safety
- Fully enclosed belt guard
- Full saddle mounting feet instead of pegged mounting feet
- Heavy-duty air filter
- Heavy-duty two-stage solid cast iron pump
- Industrial-duty engine
- Needle bearings and inserts on rods
- Pilot valve continuous operation
- Stainless steel flex lines
- Swedish steel valves
- Torrington needle bearings
- 2-groove B width drive pulley
Specs:
PN: 96-CGW30H
Engine: 13HP HONDA
CFM@175 PSI: 19
Welder Amp: 240
Generator Watt: 5000
Tank Size: 30 Gal
Generator
Outlet (Volt): 110 / 220
41 amps @ 120 Volt
20 amps @ 240 Volt
